Power Studio in DEXCell Energy Manager

Follow

This article contains the following information:

  1. Adding a Power Studio to DEXCell Energy Manager
  2. Circutor EDS

1. Adding a Power Studio to DEXCell Energy Manager

DEXCell Energy Manager is compatible with Circutor Power Studio systems. In order to start receiving data to your account follow this steps:

  1. In the upper right corner of your main page select "Settings":
  2. Once in the Settings page select Gateways
  3. Select "Register a new gateway":
  4. Select "Power Studio Engine" and click "Next":
  5. Fill the form with the information of your power studio:
  6. Click on "Search devices", select the ones you want and click on configure:dexcell energy manager configurint meters power studio
  7. You're done



#Note: For devices compatibility and IP requirements, please ask our support team at support@dexma.com

2. Circutor EDS

 



The Circutor EDS is a data logger with an embedded power studio. It's compatible with a huge range of Circutor devices either local or remote. It has 8 digital Inputs and 6 outputs. Check: How to add a Power Studio to DEXCell Energy Manager.

Official Website


#Note: For devices compatibility, please ask our support team at support@dexma.com

(check attached file: eds)


Circutor EDS - DEXCell firmware

If you have an EDS or EDS-3G capable to send data directly to DEXCell EM, you can follow these steps. For further information, have a look on the attached manual.

In order for the EDS to send data to DEXCell, you will have to update the firmware. You can download the files for the update on the Circutor website.

1) Create a Virtual Gateway following these instructions
2) Write down the mac (identifier) and the token provided by DEXCell EM. You will need this information to configure properly the EDS. Here you have more information about obtaining these parameters under your gateway. 
3) Go to your EDS remote page and configure the General Settings to start receiving data in DEXCell EM. 

  • Host: is3.dexcell.com
  • Port: 80
  • Key: Mac, obtained in the second step
  • Token: token obtained in the second step

When defining the variables to send to DEXCell, if you want to send Active Energy (DEXCell 402 parameter) at EDS you have to select the AEE (Active Energy End) variable.
 
(check the attached file: EDS_-_EDS·3G_DEXCell)
0 out of 0 found this helpful

Comments

0 comments

Please sign in to leave a comment.