Using Reactive feature


In this article we’ll go over the features of the Reactive screen.

Contents of this article:

  • Introduction
  • Requirements
  • How does it work?


The EMS Platform allows you to perform a detailed analysis of reactive energy excesses using the Reactive analysis screen. You can access it, in those licenses in which it is available, through the Analysis menu and selecting Reactive.





  1. To send data to DEXMA with, at least, the 30min frequency, as it's the minimum frequency required to get the reactive excess. 
  2. Send data with the reactive energy parameter 404. 
  3. To accept the devices and datapoints generated when the data gets into the platform.
  4. To assign those devices to its corresponding location.
  5. To configure the Supplies and Prices in the Settings section.
  6. Assign the Supplies and Prices to the devices in Settings --> Locations --> Assign supplies and prices


How does it work?

  1. Select the desired device from the available list using the selector.
  2. Select the time period for which you want to display the data.
  3. Select a reference day.
  4. You are shown to which supply the selected device is assigned.
  5. The graph shows the cost of overages discreetly - hour by hour, day by day, etc. - while the summary table calculates cumulatively taking into account the entire selected time period.
  6. You can save each graph as an image.

Was this article helpful?